CCB-PWRIO-05
The Power and I/O Breakout cable provides access to trigger and high-speed outputs. For RS-232, use the Power Supply return path for ground.
The figure on the left shows the plug on the device.
Pin# | Signal Names | Wire Color |
---|---|---|
1 | Out 2/In 2 | Yellow |
2 | TxD | White/Yellow |
3 | RxD | Brown |
4 | Out 3/In 3 | White/Brown |
5 | In 1 | Violet |
6 | Common In | White/Violet |
7 | +24 VDC | Red |
8 | GND | Black |
9 | Common Out | Green |
10 | In 0 | Orange |
11 | Out 0 | Blue |
12 | Out 1 | Grey |
Note:
- Cables are sold separately.
- Perform wiring or adjustments to I/O devices when the vision system is not receiving power.
- You can cut exposed wires short or trim wire ends. You also can tie the wires back if you use a tie made of non-conductive material. Keep bare wires separated from the +24VDC wire.