Install a Lens Filter without a Shroud

If the vision system you purchased does not have a shroud, complete the following steps to install the lens filter.

1. Verify that the 24VDC power supply is unplugged and not receiving power.
2. Remove the lens cover, if present.
3. Install the lens filter.
1. Hold the lens filter by the sides, with the threaded end towards the lens. Align the filter with the filter thread on the vision system.

2. Screw the lens filter onto the vision system by twisting it clockwise until it stops turning.

   Note: Make sure to only touch the sides of the filter to avoid leaving fingerprints on the filter.
4. Reattach the lens cover.
5. Restore power to the 24VDC power supply and turn it on if necessary.