Read Job
Reads a job from the specified In-Sight job slot.
Read Job Inputs
Syntax: RJ[ID]
Parameter | Description |
---|---|
ID |
The job ID number (0 to 999). |
Read Job Outputs
Returns a status code, followed by a line terminator, followed by lines of job data.
-
The status codes are:
Status Codes Description 1 The command was executed successfully.
0 Unrecognized command.
-1 The job ID number is outside the allowable range (0 to 999).
-2 The job could not be read, or the job slot is empty, therefore the command could not be executed. -4 The In-Sight sensor is out of memory.
-6 User does not have Full Access to execute the command. For more information, see User Access Settings Dialog.
-
The lines of job data are:
Name
The first line contains the job name.
Size
The second line contains an integer value for the size (in bytes) of the job.
Data
The actual job data is encoded as ASCII hexadecimal values formatted to 80 characters per line. Each line ends with a terminating character.
CheckSum
The last line contains four ASCII hexadecimal bytes that are a checksum of the job data.
Read Job Example
To receive information about the job named "85Test.job", which is saved on the In-Sight sensor, issue the following command: RJ85
After issuing the Read Job command, the first line outputted to the telnet window is the status code (1), followed by the job name (85Test.job) and size (1900) in bytes, then the job data (in ASCII hexadecimal format). Finally, the four-byte ASCII hexadecimal checksum is displayed on the last line (48A3).