SetNetwork
Configures settings that are found in the Network Settings dialog.
SetNetwork Inputs
Syntax: EV SetNetwork(UseDHCP,"HostName","IPAddress","SubnetMask","DefaultGateway","DNSServer","DomainName")
Parameter | Description |
---|---|
UseDHCP |
0 = Disabled 1 = Enabled |
"HostName" |
The In-Sight sensor host name. |
"IPAddress" |
The In-Sight sensor IP address. |
"SubnetMask" |
The In-Sight sensor subnet mask. |
"DefaultGateway" |
The In-Sight sensor default gateway. |
"DNSServer" |
The IP address of the gateway host. |
"DomainName" | The network domain for the In-Sight sensor. |
SetNetwork Outputs
Returns a status code, followed by the number of characters (in bytes) for the results, then the results in XML format. The status codes are:
Status Codes | Description |
---|---|
1 | The command was executed successfully. |
0 | Unrecognized command. |
-2 | The command could not be executed. |
-6 | User does not have Full
Access to execute the command. |
SetNetwork Example
To configure the following settings:
- UseDHCP: 0
- "HostName": is8402_010203
- "IPAddress": 192.168.0.1
- "SubnetMask": 255.255.255.0
- "DefaultGateway": 192.168.0.254
- "DNSServer": 192.168.0.2
- "DomainName": yourdomain.com
Issue the following command: EV SetNetwork(0,"is8402_010203","192.168.0.1","255.255.255.0","192.168.0.254","192.168.0.2","yourdomain.com")
The In-Sight sensor responds with a status code (1), followed by the number of characters, in bytes (18). Finally, the results are returned in XML format.