Set Job
Loads a job from one of the job slots in flash memory on the In-Sight sensor, making it the active job.
- The In-Sight sensor must be Offline.
- This command only works on a job saved on the flash memory on the In-Sight vision system. If the job is stored on the configured Job Server or the SD Card installed to the In-Sight vision system, this command does not work.
- To use the job ID number feature, the job to be loaded must be saved with a numerical prefix of 0 to 999.
Set Job Inputs
Syntax: SJ[ID]
Parameter | Description |
---|---|
ID | The ID number of the job to load (0 to 999). |
Set Job Outputs
Returns a status code. The status codes are:
Status Codes | Description |
---|---|
1 |
The command was executed successfully. |
0 |
Unrecognized command. |
-1 |
The ID is less than 0, or is not an integer. |
-2 |
The job failed to load, the sensor is Online or the file was not found, therefore the command could not be executed. |
-4 | The In-Sight sensor is out of memory. |
-6 |
User does not have Full Access to execute the command. For more information, see User Access Settings Dialog. |
Set Job Example
To load "85Test.job" as the active job on the In-Sight sensor, issue the following command: SJ85.
The In-Sight sensor responds with 1, indicating that the job was successfully loaded and made active.