Replace the LED Ring Light (Optional)

The illumination accessory (ISLM-7000-WHI) has a white LED ring light pre-installed. Complete the following steps to replace the pre-installed LED ring light.

CAUTION:

Do not hot-plug the illumination accessory. Verify the vision system is not receiving power when connecting or disconnecting the illumination accessory. Failure to remove power during this procedure may result in damage to the vision system and/or the illumination accessory.
Tighten all illumination accessory screws in the following sequence.

Remove power from the vision system.
Use a 2mm hex wrench to remove the four M3 x 12mm screws and remove the cover.
Remove the keyed light baffle.

Note: This step includes an optional bandpass filter accessory installed to the light baffle. For more information, refer to In-Sight Lenses, Lights and Covers.
The LED ring light screw holes are indicated by a triangle symbol ►. Use a 2mm hex wrench to remove the four M2.5 x 6mm screws and remove the LED ring light from the light housing.
Install the new LED ring light.

CAUTION: Do not hot-plug the LED ring light. Verify the vision system is not receiving power when connecting or disconnecting the LED ring light.
1. Place the new LED ring light inside the light housing, with "TOP" oriented upward.
2. Insert the four M2.5 x 6mm screws into the screw holes indicated by a triangle symbol ►.
3. Tighten the screws using a 2mm hex wrench. The maximum torque is 0.34 Nm (3 in-lb).
Install the light baffle.
1. Tilt the light baffle toward the light housing and maneuver the light baffle past the top of the LED ring light structure.
2. Compress the light baffle and maneuver the bottom of the light baffle past the bottom of the LED ring light structure until the light baffle snaps into place, with the keyed tabs sitting flush over each light housing captive screw access hole.
  Note: This step includes an optional bandpass filter accessory installed to the light baffle. For more information, refer to In-Sight Lenses, Lights and Covers.
Install the cover.
1. Place the cover on the light housing.
2. Align the central clear region of the cover with the light baffle edges.
3. Insert the four M3 x 12mm screws and use a 2mm hex wrench to torque screws to 0.31 Nm (2.75 in-lb).
Restore power to the vision system.