Content Summary
This manual covers the Cognex MVS-8600 series frame grabbers. It includes installation guidance, hardware details such as power and environmental requirements, and specifications. Additionally, it addresses using encoders with line scan cameras and supported encoder types. An appendix provides pin numbering diagrams for the Hirose HR10 connector. The document is a PDF, sized at 637 KB, and dated 09/31/2012.
This manual describes the Cognex MVS-8600 series frame grabbers in the following chapters: Chapter 1, MVS-8600 Installation, describes how you configure and install an MVS-8600 series frame grabbers.
Chapter 2, MVS-8600 Hardware, describes the MVS-8600 hardware, including environmental and power requirements, and its mechanical and electrical specifications.
Chapter 3, Using Encoders with Line Scan Cameras, describes the use of encoders with line scan cameras, and specifies the types of encoders supported.
Appendix A, Hirose HR10 Connector Pinouts provides pin numbering diagrams.
File Type: .pdf
File Size: 637 KB
Document Date: 09/31/2012
Chapter 2, MVS-8600 Hardware, describes the MVS-8600 hardware, including environmental and power requirements, and its mechanical and electrical specifications.
Chapter 3, Using Encoders with Line Scan Cameras, describes the use of encoders with line scan cameras, and specifies the types of encoders supported.
Appendix A, Hirose HR10 Connector Pinouts provides pin numbering diagrams.
File Type: .pdf
File Size: 637 KB
Document Date: 09/31/2012