AlignSight Alignment Sensor Software Installer Release 3.3.1

This installer contains the AlignSight Alignment Sensor Software. 

NEW FEATURES (3.3.0 - November 2020)

• Control Panel window for communication with supported robot controllers for robot operation and vision command execution from AlignSight Software.
• Manual Alignment menu to set runtime features pose manually when feature finding is failed. Then the last recived command can be executed again with the manually set new pose. (Only for one camera congifuration. GCP command is not supported with this workflow.) When setting an edge, in some case, trained edge region is out of the FOV, which required zooming-out to see it.
• Recipe ID assignment at creating a new recipe and recipe save as.
• When creating or saving a recipe, error message is shown if saving fails, e.g., strage is full. 

Compatibility Consideration 

• Recipe created on version 3.0, 3.1, 3.2 works with version 3.3 AlignSight Software (HMI) but Manual Alignment feature does not work. 
• To use the version 3.2 new features of L-check and Multi-Pattern for recipes created on the previous version 3.1, please follow the steps below: 1: Connect a sensor having recipes created on v3.1 2: Create any new recipe using the HMI v3.3. (This needs to be done only once on each sensor.) This updates programs on the sensor. 3: Load a recipe created on the v3.1 
• Note1: If the step 2 is skipped, the recipe is operational but behavior of the L-Check and Multi-Pattern commands are identical with v3.1. Note2: Once the step2 is applied to the sensor, the sensor can not be opened by the previous version of HMI. 

Please see the release notes for more details.