Inputs: Training a Model Pattern over an Input Line
To configure your In-Sight vision system to train a Model pattern over an input line, complete the following steps.
-
In the Pattern/Patterns (1 - 10) Location tool, Pattern Presence/Absence tool or Patterns Counting tool, select an input line to use as a train signal from the Train Input drop-down list.
Note: When connected to an In-Sight vision system or In-Sight 2000-23M vision sensor, the Train Input drop-down list is included in the Settings tab. - Go back to the Inputs/Outputs application step.
- Set the selected input line's Signal Type to Event Trigger.
- Set the Edge Type of the signal to Rising Edge, Falling Edge or Both Edges.
-
Place the In-Sight vision system/sensor Online.
Note: The training of a Model pattern will use the most recent image acquired by the vision system/sensor. It is not necessary to re-trigger the vision system/sensor in order to train. -
The edge(s) of the selected Edge Type will trigger a training of the Model pattern.