Edge Width Defect Detection Tool - Outliers Tab
When the Outliers tab is selected, the tool will display all of the found edge candidates within the region and the best-fit line or circle result. The edge candidates represent the possible edges to be considered when constructing the best-fit line or circle, and edge candidates are indicated by small, color coded circles.
The region may also be selected and adjusted when in this tab.
Any detected defects and gaps will also be displayed, as will the minimum and maximum width of the edges, which are indicated by yellow lines.
![Closed](../../Skins/Default/Stylesheets/Images/transparent.gif)
Defines whether or not the tool will re-fit the best-fit line after the edges have been re-scored (by default, this parameter is disabled).
![Closed](../../Skins/Default/Stylesheets/Images/transparent.gif)
Defines the type of best-fit line (Auto Fit, Straight Line Fit or Circle Line Fit; by default = Auto Fit) that is to be constructed out of the detected edges.
![Closed](../../Skins/Default/Stylesheets/Images/transparent.gif)
Defines whether or not the tool will remove points from the best-fit line that are further than the distance defined by the Fit Distance Filter parameter (by default, this parameter is disabled).
![Closed](../../Skins/Default/Stylesheets/Images/transparent.gif)
Defines the distance (1 - 1920; default = 2), in pixels, from which an edge must be from the original best-fit line to be utilized in a re-fit calculation. This parameter is helpful in preventing defects from affecting the line fit.