Bead Tracker Defect Detection Tool - Edges Tab
When the Edges tab is selected, the tool will display the location of the bead path in blue, all detected edges in green and the Calipers that define the polyline path, generated from the bead path location, in aqua. The aqua colored Calipers may only be adjusted through the Polyline Width parameter.You can adjust the Polyline Width, Caliper Size, Caliper Spacing and Minimum Contrast parameters, as needed, to isolate the desired edges.
Polyline Width
Defines the width of the Calipers used to define the polyline (1 - 1920; default = 25).
Caliper Size
Defines the number of pixels, per Caliper, that are to be analyzed along the direction of the inspection (1 - 639; default = 5).
Caliper Spacing
Defines the distance, in pixels, between the end of one Caliper and the start of the next Caliper (-1 - 639; default = 0).
Edge Width
Defines the pixel distance (1 - 10; default = 3) over which an edge transition takes place. This setting helps filter noise from the image.
Minimum Contrast
Defines the minimum greyscale contrast transition (1 - 255; default = 10) to be considered an edge.
Caliper Count
Displays the total number of Calipers within the region.
Caliper Index
Defines which individual Caliper to isolate and display.
Show All Calipers
Defines whether or not all of the Calipers within the region are displayed at all times; by default, the Calipers are hidden.