PatMax RedLine Patterns (1-10) and PatMax Patterns (1-10) Location Tools - Table Tab

Refers to the order of the found patterns; 1 to 10 (numerical ordering in EasyBuilder is based on 0=1).

References the center of the found pattern’s X coordinate. If a Horizontal Offset was applied, the X coordinate will be adjusted by the amount specified.

References the center of the found pattern’s Y coordinate. If a Vertical Offset was applied, the Y coordinate will be adjusted by the amount specified.

References the angle of the found pattern, relative to the Model pattern.

References how well the found pattern resembles the Model pattern.

References the scale of the found pattern.