Set Online
Sets the In-Sight sensor into Online or Offline mode. For more information, see Online/Offline.
- This command cannot place the In-Sight sensor into Online mode if the sensor has been set Offline either manually in the In-Sight Explorer user interface or by a Discrete Input signal.
- The In-Sight Explorer application will send Set Online commands to In-Sight sensors to perform administrative functions such as Backup and Restore.
Set Online Inputs
Syntax: SO[Int]
Parameter |
Description |
---|---|
Int |
|
Set Online Outputs
Returns a status code. The status codes are:
Status Codes | Description |
---|---|
1 |
The command was executed successfully. |
0 |
Unrecognized command. |
-1 |
The value given for Int is either out of range, or is not a valid integer. |
-2 |
The command could not be executed. |
-5 |
The communications flag was successful but the sensor did not go Online because the sensor is set Offline manually through the In-Sight Explorer user interface or by a Discrete I/O signal. |
-6 |
User does not have Full Access to execute the command. For more information, see User Access Settings Dialog. |
Example: Set the In-Sight Sensor Into Online Mode
To set an In-Sight sensor into Online mode, issue the following command: SO1
The In-Sight sensor responds with a status code of 1, indicating that the sensor was successfully placed Online.
Example: Set the In-Sight Sensor into Offline Mode
To set an In-Sight sensor into Offline mode, issue the following command: SO0
The In-Sight sensor responds with a status code of 1, indicating that the sensor was successfully taken Offline.