Edge Defect Detection Tool - Defects and Gaps Table Tabs
The Defects and Gaps table tabs report the first 10 detected defects/gaps, sorted by position along the edge.
Index
Refers to the order of the detected defects/gaps, sorted by position along the edge; 1 to 10 (numerical ordering in EasyBuilder is based on 0=1).
X
Returns the X coordinate (if the Calibrated Units is selected and the image was calibrated in the Set Up Image step, otherwise it reports in pixel values) of the defect/gap's bounding rectangle.
Y
Returns the Y coordinate (if the Calibrated Units is selected and the image was calibrated in the Set Up Image step, otherwise it reports in pixel values) of the defect/gap's bounding rectangle.
Area
Returns the area of the defect/gap's bounding rectangle.
Size
Returns the size (length) of the defect/gap along the edge.
Calipers
Returns the range of Calipers that the defect/gap spans.
Calibrated Units/Pixels
Defines whether or not the table displays results in real-world coordinates (Calibrated Units) or pixels (Pixels).