Adjusting the Bead Tracker Defect Detection Tool Parameters
After the tool’s region has been positioned, you can optimize the tool for your application.
The settings pane of the Bead Tracker Defect Detection Tool consists of the following tabs:
- General Tab
- Train Bead
- Edges Tab
- Edge Scoring Tab
- Defects Tab
- Gaps Tab
- Position Tab
- Statistics, Width Defects, Gaps and Position Defects Table Tabs
Tip: Test your job, using TestRun. TestRun performs tests on the In-Sight vision system and compares the results of those tests against expected values. This will allow you to see whether or not the job is behaving as expected, or if you will need to adjust certain parameters for allowable variances.